Product
Professional supplier of electronic screen printing solutions
One side Carbon fibre squeegee
- Commodity name： One side Carbon fibre squeegee
Classification:
Keywords: Squeegee | Screen | Ink
Adopting high-strength, low-density, highly corrosion-resistant custom-made carbon fibre sheet and Japanese imported rubber skin, and self-developed single-side process, it can effectively control wet weight, keep printing stable, eliminate static electricity, and help enterprises to reduce cost and increase efficiency.
Specification
Size：1.6*2.2*48*135mm；1.6*5*48*135mm。
Hardness: different hardnesses correspond to different colours
| Polyurethane squeegee MADE IN JAPAN |
Green——70（±3）A | Durometer TYPE-A GS-719N |
 |
| Blue——75（±3）A | |||
| Orange——83（±3）A | |||
| Light blue——97（±3）A |
Material
Imported polyurethane squeegee from Japan
Production process
The whole process from receiving an order to shipping
Packaging, Storage
Packaging
Paper packing:20Pcs/Box。
Storage
①Store indoors at 40°C or lower. Do not store in places with high temperature and humidity, direct sunlight and UV rays.
(Recommended storage conditions: 23°C±2°C, 60% or lower humidity).
②Do not store near heat generating equipment or dusty places.
③Prohibit bending and heavy pressure, stack flat and stack no more than 20PCS.
④After being left for a long time at low temperature, the squeegee adhesive should not be used immediately after being moved to room temperature, but should be left at 23°C for more than 3 hours before use.
Recommend products
SPS-AS carbon fiber squeegee for duplex drum screen printing machine
SPS-AS carbon fiber squeegee is suitable for reciprocating cylinder screen printing machine. It uses carbon fiber board and Japanese ASM anti-static solvent-resistant polyurethane rubber. The printing quality is stable and the service life is high.
GM-IO is a UV curable screen printing insulating ink with excellent adhesion, high flexibility, good printability and UV curing fast drying characteristics, suitable for blood glucose meters, keyboard circuits, membrane switches and so on.
In the process of screen printing, squeegee, screen plate, substrate material and other mutual friction, generating static electricity. When static electricity accumulates to a higher voltage difference, the edge of the pattern will produce flying ink, drawing and other bad.SPS-ASM anti-static squeegee resistance <108Ω, part of the charge through the squeegee dissipation, reduce the voltage difference, to avoid flying ink and wire drawing and other problems.
In the process of cell production, the effect of screen printing will directly affect the conversion efficiency of the cell, the core of printing is the aspect ratio of the silver paste after printing. Therefore, the screen, silver paste and squeegee must remain innovative, when writing higher screen printing requirements in just ten years, the requirements of the gate line is becoming more and more fine, has been from the initial 60um into the current 30um, or even finer; Subsequent to the replacement of the squeegee (as shown in the figure below), and now SPS-AS-SL single-sided photovoltaic carbon fibre squeegee is becoming more and more popular!
FGB-MP Glass Fibre Board Squeegee
SPS-MP-X series squeegee is a new generation of one-piece squeegee specially developed by Plet and Japan Polyurethane Chemical Company for the narrow line width printing of battery cells. Compared with the traditional sanding squeegee, it has significant effect on wet weight control, printing life and efficiency improvement, etc. Using this squeegee can achieve the purpose of cost reduction and efficiency improvement.
1. Manufactured using Japanese squeegee processing, it exhibits superior solvent and wear resistance; 2. The fiberglass board scraping glue combines the fiberglass board with scraping glue, offering the elasticity of the scraping glue and the structural support of the fiberglass board. This allows for a stable printing angle to be maintained even during extended periods, ensuring uniform ink thickness.